Checking the condition of the sieve and removing dirt from it
- Start working only with the vacuum cleaner switched off.
- Open the door of the Sifting module and tapping the flexible tube of the sieve so that the powder from the walls falls on the Vibrating Sieve.
- Remove the sieve locking pin and unfasten the clamping ring.
- Lift and attach the sieve Flexible tube with the flange to the magnetic holders of the Sieve flange. Put a clamping ring on the flange so that it does not fall on the sieve.
- Release the drawer locks of the sieve and Metal container.
- Pull out the Sifting module – both drawers at the same time.
- Remove the Antistatic hose from the connector for the Antistatic hose in PHS.
- Connect a PVC brush to the pulled end of the Antistatic hose.
- Check that the grounding of your ATEX Vacuum.
- Cleaner is properly installed.
- Turn on the vacuum cleaner and clean the sieve.
- When you have finished vacuuming, turn off the vacuum cleaner and remove the PVC brush from the Antistatic hose.
- Connect the Antistatic hose back to the connector for the Antistatic hose in the PHS.
- Slide the Sifting module back into the device and lock both drawers.
- Lower the Flexible tube with the sieve flange and connect with sieve, put on the clamping ring, and lock it with a locking pin.
- Close the door of the Sifting module.