Feeder clutch kit – assembly manual

To complete the assembly process, you will need:

  • Wrenches: 7mm, 17mm 
  • Allen wrenches: 5mm, 3mm, 2.5mm, 2mm.
  • 1. Disconnect the device from the power source.
  • 2. Unscrew the four screws securing the left cover of the device with a 5mm Allen wrench.
  • 3. Disconnect the feeder screw drive and Hall sensor cables.
  • 4. Unscrew the four motor mounting screws using a flat 7mm wrench.
  • 5. Unscrew the screws on the clutch side using a 2.5mm Allen wrench.
  • 6. Remove the tension screw on the clutch side using a 2mm Allen wrench.
  • 7. Extract the motor along with its mounting from the device.
  • 8. Unscrew the tension screw on the motor side using a 2.5mm Allen wrench.
  • 9. Unscrew the second one tension screw on the motor side using a 2mm Allen wrench.
  • 10. Remove the old clutch.
  • 11. Install the end of the new clutch onto the motor shaft.
  • 12. Apply a drop of the thread locker to the set screws on the tensioning spirals.
  • 13. Screw in the tension screw using moderate force until a clear resistance is felt. Use a 3mm Allen wrench
  • 14. Repeat for the second tension screw.
  • 15. Remove the old anti-vibration pads (red).
  • 16. Place the second part of the clutch onto the feeder screw, all the way to the end.
  • 17. Apply thread locker to the set screws on the tensioning spirals and tighten the clutch to the feeder screw using 4 tension screw.
  • 18. Attach larger anti-vibration pads on the left side (far from the user) and smaller ones on the right side.
  • 19. Attach the motor mounting to the device with the appropriate side. Secure it with four new screws (3mm Allen wrench).
  • 20. Adjust the Hall sensor. Loosen the nuts securing the Hall sensor using a 17mm flat wrench.
  • 21. Adjust the distance between the Hall sensor and the magnets on the clutch. Set the sensor at a distance of 3 mm from the magnet.
  • 22. Tighten the nuts securing the Hall sensor. Rotate the clutch to ensure there is no collision with both magnets.
  • 23. Connect the power wires to the motor and the Hall sensor.
  • 24. Install back cover. Screw the four screws securing the left cover of the device with a 5mm Allen wrench.